jpnevulator command not found

Introduction

When you run more command in linux terminal / console, you get the following error message

jpnevulator: command not found

or when using sudo you get the following error message

sudo: jpnevulator: command not found

Solutions to jpnevulator: command not found

How To Fix jpnevulator: command not found in Ubuntu / Debian / Kali Linux / Raspbian

In Ubuntu jpnevulator is provided by jpnevulator package.

jpnevulator is:

jpnevulator is a handy serial sniffer. You can use it to send data on a serial device too. You can read or write from/to one or more serial devices at the same time.

In write mode data to be sent on the serial device(s) is read from a file or stdin in hexadecimal notation. Data is sent on the serial device(s) line by line.

In read mode data to be read from the serial device(s) is written to a file or stdout in hexadecimal notation. It’s even possible to pass the data in between the serial device(s). Several options enhance the way the data is displayed.

To fix this problem, we can install more using the command below.

sudo apt-get -y install jpnevulator

This command might take some time to finish depending on your machine internet connection.

You can also use apt command to install jpnevulator.

sudo apt -y install jpnevulator

Or if you have aptitude installed you can use the following command.

sudo aptitude install jpnevulator

Summary

In this tutorial we learn how to fix jpnevulator command not found error in Ubuntu / Debian / Kali Linux or Raspbian distribution.